1.Claen the ground and wet the ground by binder or cement mortar

2.Mix the cement mortar and daub on the ground

3.Mix the adhesive in proportion and apply it evenly on the backofthe

tile,then smear the uninterrupted indention stripe with trowel

4.Put the tile on the ground and tapping the surface with ther ubber

hammer.Left about 2-3mm seam between two pieces of tile,then clean

with a clean towel.

5.It can not be put any heavy products or walk on the ground in 7d ays.

And use joint mixture or marble glue to filling the joint after 7 days.

6.It need crystal surface polish on the ground regularlly according to the

actual sitiation.